Product Description
Your marker can fire thousands of rounds every week, puts up with the beating of countless rainy Sundays, and withstands a number of slides through the dirt and mud. Through all of this, you still expect your marker to perform week in and week out. A small bit of maintenance is key to ensuring that your marker functions and performs at its best. One major aspect of marker maintenance is replacing your o-rings. The o-rings in your marker wear down over time by withstanding thousands of cycles along with coming in contact with dirt/debris. Our kits provide an easy and inexpensive way to keep your marker in top shape by swapping out your o-rings.
O-rings are color coded by size, eliminating the headache of matching up sizes. An included color/size chart helps with your first time rebuilding your marker. After that, just replace o-rings by color when it comes time to rebuild again. All of the o-rings you need to perform a standard rebuild of your marker three times (other quantities available). Contains o-rings for your markers firing assembly, high pressure regulator, LPR (if applicable), etc (unless otherwise noted). Don't be fooled by other kits that only offer a fraction of the o-rings needed to rebuild your marker. 007 - Hyper 3 Reg Seat 007 - LPR Piston Small) 010 - Hyper 3 Seat Housing 010 - LPR Seal Retainer 011 - Hyper 3 Top Cap 011 - Inside Bolt Stem 011 - Rear Bolt Stem 012 (x2) - LPR Body 012 - LPR Piston (Large) 013 - Hyper 3 Swivel 014 - Bolt Tip 014 - Top Hat 015 - Bolt Sail 017 - Front Wall (Internal) 017 - Top Hat 020 (x5) - Outer Sleeve 111 - Front Bumper 111 - Rear Bumper