Your marker can fire thousands of rounds every week, puts up with the beating of countless rainy Sundays, and withstands a number of slides through the dirt and mud. Through all of this, you still expect your marker to perform week in and week out. A small bit of maintenance is key to ensuring that your marker functions and performs at its best. One major aspect of marker maintenance is replacing your o-rings. The o-rings in your marker wear down over time by withstanding thousands of cycles along with coming in contact with dirt/debris. Our kits provide an easy and inexpensive way to keep your marker in top shape by swapping out your o-rings.
O-rings are color coded by size, eliminating the headache of matching up sizes. An included color/size chart helps with your first time rebuilding your marker. After that, just replace o-rings by color when it comes time to rebuild again. All of the o-rings you need to perform a standard rebuild of your marker three times (other quantities available). Contains o-rings for your markers firing assembly, high pressure regulator, LPR (if applicable), etc (unless otherwise noted). Don't be fooled by other kits that only offer a fraction of the o-rings needed to rebuild your marker. 005 (x3) - ASA 007 - Hammer Bump Stop 008 - Reg Adjuster Screw 008 - Reg Inner Retainer 008 - Reg Seat Retainer 011 - Hammer Switch 012 - LPR Piston 013 or 014 (x2) - Bolt 013 - Reg End Cap 013 - Ram Front 015 (x6) - Ram Body & Valve Body 015 - Reg Topworks 016 - Reg Piston 016 (x2) - Reg Sleeve 017 - Reg Outer Retainer 018 - Reg Bottomworks 110 - Hammer Front