Perun V3 Hybrid Mosfet - Universal Wiring (PERUN-HB-V3-UW)
Perun V3 Hybrid replaces mechanical contacts in your airsoft replica or gel blaster and provides lots of useful features. Optical and magnetic sensors allow to eliminate many moving parts that are prone to damage, thus increasing the reliability. Flexible trigger control allows you to adjust the trigger sensitivity from very short to long, even during gameplay, with any trigger and without additional modifications.
Fits most standard Tokyo Marui V3 gearboxes without the need for any modifications. Exceptions are listed in the manual.
Features:
Adjustable trigger sensitivity the trigger can be set to one of 5 sensitivity levels, from a very short pull to a full rearward pull of the trigger. No modifications to the trigger or gearbox are required, and sensitivity can be adjusted even during game.
Fully programmable fire modes at each selector position (except safe), you can set semi-automatic, burst, or full-automatic fire independently of the other positions.
Active brake active brake stops the motor after each shot preventing spring compression or in case of replicas with high rate of fire, overspin (double shot problem).
Precocking Fast trigger response can be a matter of victory or defeat, especially in CQB situations. With precocking enabled, piston will remain in rear position after each shot with the spring already compressed, ensuring that next shot will be fired immediately after you pull the trigger.
Binary trigger Allows for easy double shots in semi-automatic setting. When this mode is enabled, single shots will be fired not only when the trigger is pulled but also when it is released.
Rate of fire reduction reduce the rate of fire in automatic or burst mode to save ammunition or increase realism.
DMR mode Introduces intervals between semiautomatic shots to comply with DMR rules on some fields.
DSG mode a sector gear detection mode specially prepared to work with dual sector gears.
Discharged battery alarm Designed for Li-Po and Li-Ion batteries. If the battery voltage drops to a dangerously low level, the user will be notified by short audible signals repeated every minute.
Diagnostic system Constantly checks the condition of the electronics and the replica. In the event of a problem, it will immediately provide information about the possible cause, making troubleshooting easier.
Electronic fuse protects the replica and the battery in the event of a serious malfunction. It will automatically disconnect the battery if a short circuit is detected or if a jam occurs in the gearbox.
All settings are changed exclusively using quick and easy?to?remember sequences of fire selector movements and trigger pulls.
Perun V3 Hybrid works flawlessly with any battery rated between 7V and 17V. It can also be used with most extreme setups, without any limitations as to the spring rating.
