Inception Designs Autotrigger Plug For Slide Frames (CGP-0093)

This is a plug for an Inception Slide frame that has the Autotrigger hole in the frame.

This plug allows you to fill in the hole when using the frame on an Autococker rather than a pump Sniper.

This will ONLY fit our frames with a sliding trigger plate. It will not fit our pivot frames or other manufacturer's frames.

This can be used with a small set screw to adjust the rear stopping point of the trigger, but that's quite fiddly so we don't recommend it unless you know what you are doing and like to tinker with your trigger pull. A LOT.