Product Description
Your marker can fire thousands of rounds every week, puts up with the beating of countless rainy Sundays, and withstands a number of slides through the dirt and mud. Through all of this, you still expect your marker to perform week in and week out. A small bit of maintenance is key to ensuring that your marker functions and performs at its best. One major aspect of marker maintenance is replacing your o-rings. The o-rings in your marker wear down over time by withstanding thousands of cycles along with coming in contact with dirt/debris. Our kits provide an easy and inexpensive way to keep your marker in top shape by swapping out your o-rings.
O-rings are color coded by size, eliminating the headache of matching up sizes. An included color/size chart helps with your first time rebuilding your marker. After that, just replace o-rings by color when it comes time to rebuild again. All of the o-rings you need to perform a standard rebuild of your marker three times (other quantities available). Contains o-rings for your markers firing assembly, high pressure regulator, LPR (if applicable), etc (unless otherwise noted). Don't be fooled by other kits that only offer a fraction of the o-rings needed to rebuild your marker. 18x2mm - POPS Seal 017 - Valve Plug 017 - Front Reg Mount (Body) 016 (x2) - Shaft Barrel 015 - SL4 Swivel 14x2mm (x2) - bolt Body 14x2mm - SL4 Inline Reg Piston 014 - Bolt Pin 013 (x5) - Valve Guide, LPR Piston, LPR Body Outside, LPR Cap, Rammer Cap (Outside) 012 - Bolt Insert 011 - Rammer (Middle) 011 - SL4 Inline Reg Adjuster (Outside) 010 (x2) - Rammer (Front and Back) 010 - Rammer (Bumper) 008 - SL4 Inline Reg Adjuster (Inside) 008 - LPR Body (Inside) 007 (x4) - Gas Pipe, Pipe Nut, LPR Adjuster Screw, POPS Insert External 006 - LP Hose Barb 005 - POPS Insert (Internal) 004 - POPS Push Rod